Strong roll spacer made of fibre concrete for rolling prefabricated reinforcement cages into formwork. Simplifies the placement of the formwork on the reinforcement cages.
Large-area tunnel spacer made of fibre concrete for fixing the tunnel sealing film. On request with glued-on geotextile to protect the tunnel film and available in the dimensions 80 x 80 mm or 80 x 100 mm.
Extra strong, round spacer with flat support made of cast concrete. With eyelet wire for attachment to reinforcement. Not suitable for exposed concrete because of the flat support.
Square spacer with flat support made of cast concrete. With shuttlecock clip for easy attachment to the reinforcement. The shuttlecock clip ensures a secure hold at the crossing point of the reinforcement. Not suitable for exposed concrete because of the flat support.
Square spacer with flat support made of cast concrete. With plastic clip for easy attachment to reinforcement. Not suitable for exposed concrete because of the flat support.
Square spacer with flat support made of cast concrete. With eyelet wire for attachment to reinforcement. Not suitable for exposed concrete because of the flat support.
Fibre-reinforced concrete tube, cut on both sides, for the production of formwork clamping points on the construction site. By cutting the tube to length, the required lengths can be produced on site. Suitable for tie rods with DYWIDAG thread 15 mm. Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Pre-cut fibre-reinforced concrete tube for the production of formwork clamping points on the construction site. Suitable for tie rods with DYWIDAG thread 15 mm. Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Fibre-reinforced concrete plug for closing the fibre-reinforced concrete tube with diameter 22 mm. Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Prefabricated cone in high quality exposed concrete to close tie holes. Suitable for cone 22 with fitting length 10mm. After removing the cone, the exposed concrete cone is glued into the conical opening. A small shadow gap is left.
Prefabricated cone in high-quality exposed concrete for closing tie holes with an inner diameter of 22 to 26 mm in combination with cones with a fitting length of 10 mm as well as OKTAGON-PLUS 22 or 26. The Sichtbetonkegel Universal is only used to visually close the tie hole and does not provide protection against water under pressure.
Cone in high-quality fair-faced concrete for closing clamping points. After removing the cone K22/5 or K26/5, the exposed concrete cone is glued into the conical opening. The cone is slightly shorter than the conical opening, which results in the formation of a shadow gap.